G6 L4-2.4L VIN B (2006)
Important:
You MUST properly install the teeth into the upper column bracket to prevent steering column movement in the event of a collision.
1.
If the tilt teeth and/or detent lever was removed, carefully reinstall in the correct orientation as shown.
^
Line up the teeth in the proper orientation.
^
Compress the tooth spring within compression bracket slot.
Important:
Grease the cam surface with P/N 89021688 (Canadian P/N 89021674). Subassemble spacer to bolt retainer.
2.
Align with the tilt teeth and attach to the side of the tilt bracket.
3.
Subassemble the cam follower to release the follower.
^
Align with the tilt teeth and attach to the side of the tilt bracket.
^
Align with the tilt teeth and attach to the side of the tilt bracket.
4.
Assemble the tilt lever through components.
5.
Attach the thrust washer and preassemble the new torque prevailing nut.
