G6 L4-2.4L VIN B (2006)
1.
If the tilt teeth and/or detent lever was removed, carefully reinstall in the correct orientation as shown.
^
Line up the teeth in the proper orientation.
^
Compress the tooth spring within compression bracket slot.
Important:
Grease the cam surface with P/N 89021688 (Canadian P/N 89021674). Subassemble spacer to bolt retainer.
2.
Align with the tilt teeth and attach to the side of the tilt bracket.
3.
Subassemble the cam follower to release the follower.
^
Align with the tilt teeth and attach to the side of the tilt bracket.
4.
Assemble the tilt lever through components.
5.
Attach the thrust washer and preassemble the new torque prevailing nut.
6.
Hold the tilt lever, with light pressure, against the cam follower. Actuate the lever to position against closed stop detent. Lever handle should be
approximately parallel with the work surface.
Note:
Refer to Fastener Notice.
