G6 L4-2.4L VIN B (2006)
5. Connect the intermediate steering shaft to the steering gear as noted during removal.
6. Install the new intermediate steering shaft to steering gear pinch bolt.
Tighten
Tighten the bolt to 49 Nm (36 lb ft).
7. Position the outer tie rod ends into the steering knuckles.
Important: Hold the ball stud from turning during installation of the castle nut.
8. Install new torque castle nuts to the tie rod end ball studs.
Tighten
Tighten the castle nuts to 25 Nm (18 lb ft) plus 90 degrees.
9. Install the front tires and wheels.
10. Lower the vehicle.
11. Measure the wheel alignment and adjust as necessary. Refer to Wheel Alignment Measurement See: Alignment/Specifications.
