G6 L4-2.4L VIN B (2006)
1. Install the following components on the suspension crossmember if removed:
-
The stabilizer shaft--Refer to Stabilizer Shaft Replacement See: Stabilizer Bar/Service and Repair.
-
The lower control arms--Refer to Lower Control Arm Replacement See: Control Arm/Service and Repair.
2. Lower the vehicle on to the frame.
3. Install the frame reinforcements (3).
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners
requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use
paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint
clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid
damage to parts and systems.
4. Install the rear frame bolts (4).
Tighten
Tighten the bolts to 100 Nm (74 lb ft) plus 180 degrees rotation.
5. Install the front frame bolts (1).
Tighten
Tighten the bolts to 100 Nm (74 lb ft) plus 180 degrees rotation.
6. Install the reinforcement bolts (1).
Tighten
Tighten the bolts to 50 Nm (37 lb ft).
