G6 L4-2.4L VIN B (2006)
1. Cut the park lock cable adjuster and cable off at the location just before the end of the retaining barb.
2. Tie the inhibitor end of the new cable to the old cable in an overlapping fashion using zip ties or electrical tape.
3. Carefully use the old cable to route the new cable. If the cable becomes stuck, move the lower part of the cable toward the RH side of the vehicle
while pulling the upper half gently.
4. The cable is routed between the HVAC plenum and the vehicle cowl.
5. Place the shift lever in P (Park).
6. Snap the control cable connector into the automatic transmission control.
7. Place the ignition key in the RUN position.
8. Important: Do not insert the cable with the key in any other position.
Snap the control cable into the inhibitor housing until the snap lock is seated.
9. Turn the key to the LOCK position.
10. Snap the control cable end onto the shift park/lock lever pin.
Important: Ensure that the park lock cable functions as designed. With the key in the OFF position, the shift lever should not be able to be
