G6 L4-2.4L VIN B (2006)
4. Notice: Refer to Fastener Notice.
Align the following items:
^
The halfshaft inboard seal (1)
^
The halfshaft bar
^
The swage ring (2)
Tighten each bolt of J41048 180 degrees at a time using a ratchet wrench. Alternate between each bolt until both sides are bottomed.
5. Slide the tripot joint spider assembly as far as it will go on the halfshaft bar.
6. Important: The spacer ring MUST be fully seated into the groove on the halfshaft bar.
Use J8059 to install the spacer ring (1) into the groove of the halfshaft bar.
