G6 L4-2.4L VIN B (2006)
Install the 3 hub and bearing assembly bolts.
Tighten the hub and bearing assembly bolts to 115 Nm (85 ft. lbs.)
3. Install the wheel speed sensor connector into the bracket until the locking tabs click into place, if equipped with ABS.
4. Connect the electrical connector to the wheel speed sensor, if equipped with ABS.
5. Install the axle nut to the wheel drive shaft, hand tighten the wheel drive shaft nut.
6. Install the brake rotor.
7. Install the wheel drive shaft nut to the wheel drive shaft.
8. Use a screw driver or similar tool to stop the rotation of the brake rotor.
Tighten the wheel drive shaft nut to 215 Nm (159 ft. lbs.)
9. Install the tire and wheel assemblies.
