G6 V6-3.5L (2009)
Heated Seat Switch Circuit Test.
1. Ignition OFF, disconnect the harness connector at the appropriate heated seat switch.
2. Test for less than 5 Ohms between the ground circuit terminal 6 and ground.
‹› If greater than the specified range, test the ground circuit for an open/high resistance.
3. Ignition ON, verify that a test lamp illuminates between the B+ circuit terminal 5 and ground.
‹› If the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance.
4. If all circuits test normal, test or replace the heated seat switch.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic Trouble
Code Tests and Associated Procedures/Verification Tests and Procedures) after completing the diagnostic procedure.
*
Driver or Passenger Seat Back Cushion Heater Replacement (See: Service and Repair/Driver or Passenger Seat Back Cushion Heater
Replacement)
*
Driver or Passenger Seat Heater Switch Replacement (See: Seat Heater Switch/Service and Repair)
*
Front Seat Heater Control Module Replacement (See: Seat Heater Control Module/Service and Repair)
*
Driver or Passenger Seat Cushion Heater Replacement (See: Service and Repair/Driver or Passenger Seat Cushion Heater Replacement)