G6 V6-3.5L (2009)
7. Remove the support, and install the brake caliper and the brake caliper bracket as an assembly to the steering knuckle. Refer to Front Brake
Caliper Bracket Replacement (See: Brake Caliper/Service and Repair/Removal and Replacement/Front Brake Caliper Bracket Replacement).
8. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service and Repair).
9. Lower the vehicle.
10. If the brake rotor was refinished or replaced, or if new brake pads were installed, burnish the pads and rotors. Refer to Brake Pad and Rotor
Burnishing (See: Brake Pad/Service and Repair/Brake Pad and Rotor Burnishing).
Rear Brake Rotor Replacement
Rear Brake Rotor Replacement
Special Tools
*
J 41013 Rotor Resurfacing Kit
*
J 42450-A Wheel Hub Resurfacing Kit
Removal Procedure
1. Check to be sure that the park brake is released.
2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair).
3. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service and Repair
).
Caution: Support the brake caliper with heavy mechanic wire, or equivalent, whenever it is separated from its mount and the hydraulic flexible
brake hose is still connected. Failure to support the caliper in this manner will cause the flexible brake hose to bear the weight of the caliper, which
may cause damage to the brake hose and in turn may cause a brake fluid leak.
Note: Do NOT disconnect the hydraulic brake flexible hose from the caliper.
4. Remove the brake caliper mounting bracket and caliper as an assembly from the suspension knuckle and support the assembly with heavy
mechanic's wire, or equivalent. Ensure that there is no tension on the hydraulic brake flexible hose. Refer to Rear Brake Caliper Bracket
Replacement (See: Brake Caliper/Service and Repair/Removal and Replacement/Rear Brake Caliper Bracket Replacement).
5. Matchmark the position of the brake rotor to the wheel studs.
6. Remove the brake rotor. Do not force the rotor off. If the rotor is difficult to remove, ease it off by gently rotating it as you pull outward.
Installation Procedure
Note: Whenever the brake rotor has been separated from the hub/axle flange, any rust or contaminants should be cleaned from the hub/axle flange
and the brake rotor mating surfaces. Failure to do this may result in excessive assembled lateral runout (LRO) of the brake rotor, which could lead
to brake pulsation.
