G6 V6-3.5L (2009)
4. Hold the rotor firmly in place against the hub/axle flange and install one of the J-45101-100 - Conical Brake Rotor Washers (1), and one lug nut
(2) onto the upper-most wheel stud.
5. Continue to hold the rotor secure and tighten the lug nut firmly by hand.
6. Install the remaining J-45101-100 - Conical Brake Rotor Washers and lug nuts onto the wheel studs and tighten the nuts firmly by hand in a
star-pattern.
7. Using the J-39544-KIT - Torque-Limiting Socket Set , or equivalent, tighten the lug nuts in a star-pattern to specification, in order to properly
secure the rotor. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service and Repair).
8. If the brake rotor has been REFINISHED or REPLACED with a new rotor, proceed to step 14.
9. If the brake rotor meets the following criteria, proceed to step 10.
*
The rotor is within specifications and is being REUSED.
*
The rotor has NOT been refinished.
*
The rotor does NOT exhibit thickness variation exceeding the maximum allowable level.