G6 V6-3.5L (2009)
1. Install the brake caliper mounting bracket to the steering knuckle.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the brake caliper mounting bracket bolts (1) and tighten to 130 Nm (96 lb ft).
3. Apply a very thin coating of high temperature silicone brake lubricant to the pad hardware mating surfaces (1) of the caliper bracket only.
4. Clean the brake pad mating surfaces of the brake pad retainers (2).
5. Install the brake pad retainers (2) to the brake caliper bracket.
Note: The wear sensor equipped disc brake pad must be mounted inboard of the rotor with the leading edge of the sensor facing the brake rotor
during forward wheel rotation, or at the top of the pad when installed in vehicle position.
6. Install the brake pads (2) to the brake caliper bracket.
7. Remove the support (1) and reposition the brake caliper over the brake pads and to the mounting bracket. Refer to Front Brake Caliper
Replacement (See: Front Brake Caliper Replacement).
