G6 V6-3.5L (2009)
8. Loosen the rocker arm cover bolts.
Note: When removing the valve rocker arm cover make sure the gasket stays in place attached to the cylinder head.
9. Remove the rocker arm cover (2). If necessary, bump the end of the cover with the palm of your hand or a soft rubber mallet if the cover adheres
to the cylinder head.
10. Cut the room temperature vulcanizing (RTV) sealer in the channel where the intake, cylinder head, and rocker cover meet with a suitable tool.
11. Remove the rocker arm cover gasket.
Installation Procedure
1. All gasket mating surfaces need to be free of oil and foreign material. Use GM P/N 12346139 (Canadian P/N 10953463) or equivalent to clean the
surfaces.
2. Install the rocker arm cover gasket into the rocker arm cover.
3. Apply sealer to the surfaces where the cylinder head and the intake manifold meet (1). Refer to Adhesives, Fluids, Lubricants, and Sealers (See:
Specifications/Adhesives, Fluids, Lubricants, and Sealers).
4. Place the rocker arm cover (2) onto the cylinder head.