G6 V6-3.5L (2009)
Note: Connect the actuator rod (3) to the detent lever assembly.
1. Install the manual shaft detent (w/shift position switch) lever assembly (4).
Note: Lubricate the shaft with automatic transmission fluid to prevent damage to the manual shift shaft seal during installation.
2. Install the manual shaft (2).
3. Install the manual shaft detent lever hub pin (1) using DT-48550 .
Install the Manual Shaft Detent Lever Hub Pin to height of (b) 7.9 mm (0.38 in).
Caution: Use J 41229 to install the manual shaft pin at the correct height in order to properly secure the manual shaft. If you install the pin too
deep, the case bore may crack.
4. Install the NEW manual shift shaft pin (5) using J 41229 . Use a NEW pin to ensure proper engagement with the case.
Inspect pin installed height is within (a) 7.2-8.2 mm (0.28-0.32 in).
5. Install the control valve body. Refer to Control Valve Body Replacement (See: Transmission and Drivetrain/Automatic
Transmission/Transaxle/Valve Body/Service and Repair/6T40/6T45 - Automatic Transmission/Control Valve Body Replacement).
6. Perform the service fast learn adapt procedure. Refer to Service Fast Learn Adapts (See: Transmission and Drivetrain/Automatic
Transmission/Transaxle/Testing and Inspection/Component Tests and General Diagnostics/6T40/6T45 - Automatic Transmission/Service Fast
Learn Adapts).
