G6 V6-3.5L (2009)
Vehicle Speed Sensor: Service and Repair
4T45-E - Automatic Transmission
Vehicle Speed Sensor Replacement
Removal Procedure
Warning
Ensure that the vehicle is properly supported and squarely positioned. To help avoid personal injury when a vehicle is on a hoist, provide additional
support for the vehicle on the opposite end from which the components are being removed.
1. Position the vehicle on a hoist and raise the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and
Repair).
2. Disconnect the vehicle speed sensor (VSS) electrical connector.
3. Remove the VSS electrical harness retainer from the VSS stud.
4. Remove the VSS stud.
5. Remove the output VSS from the transmission case.
Note: Inspect the O-ring for damage and replace if necessary.
6. Remove the O-ring from the VSS.
Installation Procedure
