G6 V6-3.5L (2009)
1. Install the intermediate steering shaft from inside the vehicle.
Note: Do NOT twist or squeeze the seal during installation and position it in its original position. Ensure the it is properly seated and inspect the 4
lock tabs from the engine side for any damage. If the intermediate steering shaft seal lock tabs are damaged then replace the seal.
2. Seat the intermediate steering shaft seal by pushing it forward from the inside of the vehicle until all four lock tabs are fully seated.
3. Connect the intermediate steering shaft to the steering column.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
4. Install the new intermediate steering shaft bolt.
*
For electronic power steering, tighten the bolt to 49 Nm (36 lb ft).
*
For hydraulic power steering, tighten the bolt to 62 Nm (46 lb ft).
5. Install the left side instrument panel insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side (See: Body and
Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair).
