G6 V6-3.5L (2009)
Steering Angle Sensor: Service and Repair
Steering Wheel Position Sensor Replacement
Steering Wheel Position Sensor Replacement
Tools Required
J 42640 Steering Column Anti Rotation Pin
Removal Procedure
1. Lock the steering column through the access hole in the lower trim cover using J 42640 .
Important: If replacing the sensor, a new sensor MUST come with a pin installed. If pin is not installed, return and reorder sensor. Do
not apply force to the sensor and the bearing assembly in a sideways direction.
When reusing the sensor you must install a pin into the sensor before it is removed from the steering shaft. By not installing a pin into the
sensor it will cause the sensor to lose its centering position and must be discarded.
Pin diameter must be in the range of 1.0-2.0 mm.
2. Remove the intermediate shaft from the steering column shaft. Refer to Intermediate Steering Shaft Replacement (See: Steering/Steering
Column/Service and Repair/Intermediate Steering Shaft Replacement).
3. Remove the sensor connector by using a suitable tool in order to pull the connector down around the right side of the steering column for
accessibility.
4. Remove the sensor from the steering shaft.
Assembly Procedure
