G6 V6-3.5L (2009)
7. Coat the filter O-ring seal with a small amount of petroleum jelly, and install the filter into the transaxle case.
Caution: Push straight down on the center of the oil level control valve in order to prevent damage to the case bore.
8. Install the oil level control valve.
9. Install the transaxle oil pan and gasket. Refer to Oil Pan Replacement (See: Fluid Pan/Service and Repair/4T45-E - Automatic Transmission).
10. Lower the vehicle.
11. Add DEXRON(R) VI transaxle fluid or equivalent.
*
The bottom pan removal capacity is approximately 6.5 L (6.9 qt).
*
The complete overhaul capacity is approximately 9 L (9.5 qt).
*
The dry capacity is approximately 12.2 L (12.9 qt).
12. Start the engine, warm up the transaxle, and check for leaks.
13. Check the fluid level. Refer to Transmission Fluid Check (See: Testing and Inspection/Symptom Related Diagnostic Procedures/4T45-E -
Automatic Transmission/Transmission Fluid Check).
Note: It is recommended that transmission adaptive pressure (TAP) information be reset.
Resetting the TAP values using a scan tool will erase all learned values in all cells. As a result, The ECM, PCM or TCM will need to relearn TAP
values. Transmission performance may be affected as new TAP values are learned.
14. Reset the TAP values. Refer to Transmission Adaptive Functions (See: Description and Operation/4T45-E - Automatic
Transmission/Transmission Adaptive Functions).
Transmission Fluid Cooler Pipe Seal Replacement
Transmission Fluid Cooler Pipe Seal Replacement
Special Tools
*
J 41239 Cooler Line Seal Remover/Installer
*
J 45201 Cooler Line Seal Remover
Removal Procedure
Warning
Ensure that the vehicle is properly supported and squarely positioned. To help avoid personal injury when a vehicle is on a hoist, provide additional
support for the vehicle on the opposite end from which the components are being removed.
1. Position the vehicle on a hoist.
2. Place a drain pan or suitable container under the vehicle.
