G6 V6-3.5L (2009)
Note: Carefully guide the axle shaft past the lip seal. Do not allow the shaft splines to contact any portion of the seal lip surface, otherwise
damage to the seal will occur.
10. Install the stub shaft into the transmission. Use a mallet to fully seat the shaft.
11. Install the drive axle assembly. Refer to Wheel Drive Shaft Replacement (See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service
and Repair).
12. Lower the vehicle.
13. Inspect the oil level. Refer to Transmission Fluid Check (See: Testing and Inspection/Symptom Related Diagnostic Procedures/4T45-E -
Automatic Transmission/Transmission Fluid Check).
14. Inspect the shaft and the seal for leaks.
