G6 V6-3.5L (2009)
6. Reposition and connect the electrical connectors to the following:
*
Automatic transaxle fluid pressure manual valve position switch assembly (395)
*
2-3 shift solenoid valve assembly (315B)
*
Internal mode switch (IMS)
Note: It is recommended that transmission adaptive pressure (TAP) information be reset.
Resetting the TAP values using a scan tool will erase all learned values in all cells. As a result, the engine control module (ECM), powertrain
control module (PCM) or transmission control module (TCM) will need to relearn TAP values. Transmission performance may be affected as new
TAP values are learned. Reset the TAP values. Refer to Transmission Adaptive Functions (See: Automatic Transmission/Transaxle/Description
and Operation/4T65-E - Automatic Transmission/Transmission Adaptive Functions).
7. Install the case side cover. Refer to Control Valve Body Cover Replacement (See: Automatic Transmission/Transaxle/Valve Body/Service and
Repair/4T65-E - Automatic Transmission/Control Valve Body Cover Replacement).
Torque Converter Clutch Solenoid Replacement
Torque Converter Clutch Solenoid Replacement
Removal Procedure
1. Remove the case side cover. Refer to Control Valve Body Cover Replacement (See: Automatic Transmission/Transaxle/Valve Body/Service and
Repair/4T65-E - Automatic Transmission/Control Valve Body Cover Replacement).
2. Disconnect the torque converter clutch (TCC) solenoid electrical connector.
3. Remove the TCC solenoid retaining clip (314)
4. Remove the TCC solenoid (315).
Installation Procedure
