G6 V6-3.5L VIN 8 (2005)
INSTALLATION PROCEDURE
1. Starting at the bottom, install the garnish molding to the vehicle.
2. Position the seat belt D-ring and install the D-ring fastener.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the fastener to 35 N.m (25 lb ft).
3. Enable the roof rail SIR system. Refer to SIR Disabling and Enabling Zone 8 in Restraint Systems.
Garnish Molding Replacement - Rear Corner Upper
GARNISH MOLDING REPLACEMENT - REAR CORNER UPPER
REMOVAL PROCEDURE