G6 V6-3.5L VIN 8 (2005)
Test Description
The numbers below refer to the step numbers on the diagnostic table.
2. This test is to verify that the symptom is present during diagnosing. Other vehicle components may cause a similar symptom such as the exhaust
system, or the drivetrain.
3. This test is to verify that the drive belts or accessory drive components may be causing the vibration. When removing the drive belt, the water
pump may not be operating and the engine may overheat. Also DTCs may set when the engine is operating with the drive belt removed.
4. The drive belts may cause a vibration. While the drive belts are removed, this is the best time to inspect the condition of the belt.
6. Inspecting of the fasteners can eliminate the possibility that a wrong bolt, nut, spacer, or washer was installed.
8. This step should only be performed if the fan is driven by the drive belt. Inspect the engine cooling fan for bent, twisted, loose, or cracked blades.
Inspect the fan clutch for smoothness, ease of turning. Inspect for a bent fan shaft or bent mounting flange.
9. This step should only be performed if the water pump is driven by the drive belt. Inspect the water pump shaft for being bent. Also inspect the
water pump bearings for smoothness and excessive play. Compare the water pump with a known good water pump.
10. Accessory drive component brackets that are bent, cracked, or loose may put extra strain on that accessory component causing it to vibrate.
