G6 V6-3.6L (2007)
13. Remove the wire or string from the hood release cable.
Installation Procedure
1. Tie the wire or string to the hood release cable.
2. Install the hood primary latch release cable through the hole in the instrument panel.
3. Install the hood release cable through the instrument panel using a small flat-bladed tool until the grommet is fully seated.
4. Remove the wire or string from the hood release cable.
5. Install the hood latch release cable ball to the latch.
Notice: Refer to Fastener Notice.
6. Install the hood latch fasteners.
Tighten the fasteners to 10 N.m (89 lb in).
7. Install the upper fascia support.