G6 V6-3.6L (2007)
Sun Shade: Service and Repair
Sunroof Manual Operation
SUNROOF MANUAL OPERATION
In event of a power failure, the sunroof window panel may be opened or closed manually. The headliner will need to be lowered in the rear to access the
motor/actuator which has an allen head on the bottom side of the drive gear. Use of an allen wrench will allow manual cranking of the motor and drive
gear. After each manual operation of the sunroof, the motor must be reprogrammed by performing the Initialization/Teach procedure. Refer to Sunroof
Motor/Actuator Initialization/Teach Process (Existing Motor) Sunroof Motor/Actuator Initialization/Teach Process (New Motor) Sunroof
Motor/Actuator Initialization/Teach Process (Panoramic). See: Sunroof / Moonroof Motor/Service and Repair/Procedures
Sunroof Sunshade Motor/Actuator Replacement
SUNROOF SUNSHADE MOTOR/ACTUATOR REPLACEMENT
REMOVAL PROCEDURE
1. Partially remove and lower the headliner.
2. Disconnect the electrical connector from the sunshade motor right rear.
3. Remove the screws from the sunshade motor.
4. Pulling straight down to disengage the drive gear from the cables.
5. Remove the sunshade motor from the sunroof module.
INSTALLATION PROCEDURE
