G6 V6-3.6L (2007)
Brake Master Cylinder: Removal and Replacement
Master Cylinder Reservoir Replacement
Master Cylinder Reservoir Replacement
Caution: Refer to Brake Fluid Irritant Caution .
Notice: Refer to Brake Fluid Effects on Paint and Electrical Components Notice .
Removal Procedure
1. Remove the master cylinder from the vehicle.
2. Remove the fluid level sensor.
3. Drain the brake fluid from the master cylinder reservoir.
4. Secure the mounting flange of the brake master cylinder in a bench vise so the rear of the primary piston is accessible.
5. Carefully tap out the reservoir retaining pins until clear of reservoir.
6. Remove the reservoir from the master cylinder.
7. Remove the seals from the master cylinder reservoir.
Installation Procedure
1. Inspect the reservoir for cracks or deformities. If found, replace the reservoir.
2. Clean the reservoir with clean denatured alcohol, or equivalent.
