G6 V6-3.6L (2007)
3. Rotate the steering wheel to both steering stops while activating each cruise control switch separately. With a scan tool, observe the Cruise Control
Switch parameters in the BCM. Ensure that each cruise control switch activated and that each displayed switch position in the Cruise Control
Switch parameter match as the steering wheel is turned. This will help eliminate the possibility of an internally open or shorted inflatable restraint
steering wheel module coil.
Circuit/System Testing
Caution: Refer to Restraint System Service Precautions.
Disable the inflatable restraint steering wheel module when performing this diagnostic. Refer to SIR Disabling and Enabling.
1. Ignition OFF, remove the inflatable restraint steering wheel module. Refer to Inflatable Restraint Steering Wheel Module Replacement.
2. Disconnect the harness connector of the cruise control switch.
3. Ignition ON, measure for 10 volts or greater at the cruise control supply voltage circuit.
‹› If less than the specified value, check for an open/high resistance or for a short to ground on the cruise control supply voltage circuit.
4. Ignition OFF, test for an open/high resistance, a short to ground, or a short to voltage in the cruise control switch signal circuit.
5. Test the component. If the circuits and the component tests are normal, replace the BCM.
Component Testing
Caution: Refer to Restraint System Service Precautions.
Disable the inflatable restraint steering wheel module when performing this diagnostic. Refer to SIR Disabling and Enabling.
Important: The cruise control ON/OFF switch must be ON in order to properly measure the resistance of the ON, - Set/Cruise, and the +
Resume/Accelerate switches.
1. Ignition OFF, remove the inflatable restraint steering wheel module. Refer to Inflatable Restraint Steering Wheel Module Replacement.
2. Ignition OFF, disconnect the cruise control harness connector at the inflatable restraint steering wheel module coil.
3. Measure the resistance between terminals E and F (E and H for the Cancel Switch) at the cruise control switch side of the connector. Individually
activate and hold each cruise control function switch and compare the resistance reading to the values on the schematic for the ON/OFF, - SET,
the + RES, and the Cancel switches.
‹› If any of the resistance measurements for the OFF, ON, - SET, + RES, and Cancel switches are not within the listed resistance values, replace
the cruise control switch assembly.
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
*
Steering Wheel Control Switch Assembly Replacement
*
Refer to Programming and Relearning. See: Testing and Inspection/Programming and Relearning
