G6 V6-3.6L (2007)
Evaporative Emissions Hose: Service and Repair
Evaporative Emission (EVAP) Hoses/Pipes Replacement - Chassis/Canister
Evaporative Emission Hoses/Pipes Replacement - Chassis/Canister
Removal Procedure
1. Relieve the fuel system pressure. Refer to Fuel Pressure Relief (With CH 48027) Fuel Pressure Relief (Without CH 48027).
2. Remove the fuel injector sight shield.
3. Remove the fuel feed pipe clip nut (2) from the intake manifold stud.
4. Disconnect the fuel feed pipe (1) quick connect fitting from the fuel rail.
5. Disconnect the evaporative emission (EVAP) pipe (3) quick connect fitting from the EVAP purge solenoid.
6. Cap the fuel rail pipe and the EVAP purge solenoid in order to prevent possible fuel and/or EVAP system contamination.
7. Remove the brake, fuel, and EVAP pipe clips (1, 2) from the studs on the front of dash.
8. Remove the brake pipes from the clips.
