G6 V6-3.6L (2007)
Ignition Coil: Service and Repair
Ignition Coil(s) Replacement - Bank 1
Ignition Coil Replacement - Bank 1
Removal Procedure
1. Remove the fuel injector sight shield.
2. Disconnect the engine wiring harness electrical connector(s) (3) from the ignition coil(s).
3. If removing the number 5 cylinder ignition coil, remove the evaporative emission (EVAP) canister purge tube. Refer to Evaporative Emission
Canister Purge Tube Replacement.
4. Remove the ignition coil bolt(s).
5. Remove the ignition coil(s).
Installation Procedure