G6 V6-3.6L (2007)
Crankshaft Position Sensor: Service and Repair
Crankshaft Position System Variation Learn
Crankshaft Position System Variation Learn
Important: The Crankshaft Position (CKP) system variation learn procedure is also required when the following service procedures have been
performed, regardless of whether DTC P0315 is set:
* An engine replacement
* A engine control module (ECM) replacement
* A crankshaft balancer replacement
* A crankshaft replacement
* A CKP sensor replacement
* Any engine repairs which disturb the crankshaft to CKP sensor relationship.
Important: The ECM monitors certain component signals to determine if all the conditions are met to continue with the CKP System Variation
Learn Procedure. The scan tool only displays the condition that inhibits the procedure. The scan tool displays the signals of the following
components:
* CKP sensors activity-If there is a CKP sensor condition, refer to the applicable DTC that set.
* Camshaft position (CMP) signal activity-If there is a CMP signal condition, refer to the applicable DTC that set.
* Engine coolant temperature (ECT)-If the engine coolant temperature is not warm enough, idle the engine until the engine coolant
temperature reaches the correct temperature.
1. Install a scan tool.
2. Monitor the ECM for DTCs with a scan tool. If other DTCs are set, except DTC P0315, refer to Diagnostic Trouble Code (DTC) List - Vehicle
for the applicable DTC that set. See: Computers and Control Systems/Testing and Inspection/Diagnostic Trouble Code Descriptions
3. With a scan tool, select the CKP System Variation Learn Procedure and perform the following:
1. Block the drive wheels.
2. Set the parking brake.
3. DO NOT apply the brake pedal.
4. Cycle the ignition from OFF to ON.
5. Apply and hold the brake pedal for the duration of the procedure.
6. Start and idle the engine.
7. Turn the air conditioning (A/C) OFF.
8. The vehicle must remain in Park or Neutral.
Important: While the learn procedure is in progress, release the throttle immediately when the engine starts to decelerate. The engine
control is returned to the operator and the engine responds to throttle position after the learn procedure is complete.
9. Accelerate to wide open throttle (WOT) and release when the fuel cut-off occurs.
4. The scan tool displays Learn Status: Learned this Ignition. If the scan tool indicates that DTC P0315 ran and passed, the CKP variation learn
procedure is complete. If the scan tool indicates DTC P0315 failed or did not run, refer to DTC P0315. If any other DTCs set, refer to Diagnostic
Trouble Code (DTC) List - Vehicle for the applicable DTC. See: Computers and Control Systems/Testing and Inspection/Diagnostic Trouble
Code Tests and Associated Procedures/P Code Charts/P0315 See: Computers and Control Systems/Testing and Inspection/Diagnostic Trouble
Code Descriptions
5. Turn OFF the ignition for 30 seconds after the learn procedure is completed successfully in order to store the CKP system variation values in the
ECM memory.
