G6 V6-3.6L (2007)
harness conduit. Tape back over the harness to the connector creating a double layer of tape.
Important
DO NOT substitute with vinyl electrical tape or friction tape. Use only the tape specified above.
10. Connect the seat harness connector to the PPS connector (1). Insert the connector/clip to the seat frame.
11. Secure the new harness to the seat frame using tie straps at the locations shown above (1).
6. Connect the seat cushion heater connector (1) to the heated seat control module. Secure the heated seat harness to the adjacent harness using a tie
strap as shown above (2).
