G6 V6-3.6L (2007)
5. Connect the intermediate steering shaft to the steering gear as noted during removal.
6. Install the new intermediate steering shaft to steering gear pinch bolt.
Tighten the bolt to 49 N.m (36 lb ft).
7. Position the outer tie rod ends into the steering knuckles.
Important: Hold the ball stud from turning during installation of the castle nut.
8. Install new torque castle nuts to the tie rod end ball studs.
Tighten the castle nuts to 60 N.m (44 lb ft).
9. Install the front tires and wheels.
10. Lower the vehicle.
11. Measure the wheel alignment and adjust as necessary. Refer to Measuring Wheel Alignment.
Steering Gear Replacement (Hydraulic Power Steering)
Steering Gear Replacement (Hydraulic Power Steering LY7)
Tools Required
J 24319-B Universal Steering Linkage and Tie Rod Puller
Removal Procedure
Notice: Secure the steering wheel utilizing a strap to prevent rotation. Locking of the steering column will prevent damage and a possible
malfunction of the SIR system. The steering wheel must be secured in position before disconnecting the following components:
^
The steering column
^
The intermediate shaft
^
The steering gear
After disconnecting these components, do not move the front tires and wheels. Failure to follow these procedures may cause improper alignment
of some components during installation and result in possible damage to the SIR coil.
Turn the steering wheel to the straight forward position, support it from movement.
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the front tires and wheels.
