G6 V6-3.6L (2007)
11. Tighten the transaxle mount through bolt.
Tighten the transaxle mount through bolt to 50 N.m (37 lb ft).
12. Position the outer tie rod ends into the steering knuckles.
Important: Hold the ball stud from turning during installation of the castle nut.
13. Install new torque castle nuts to the tie rod end ball studs.
Tighten the castle nuts to 25 N.m (18 lb ft) plus an additional 90 degree rotation.
14. Install the front tires and wheels.
15. Lower the vehicle.
16. Fill and bleed the power steering system. Refer to Power Steering System Bleeding.
17. Measure the wheel alignment and adjust as necessary. Refer to Measuring Wheel Alignment.
