G6 V6-3.6L (2007)
6. Inspect all components for damage.
7. Inspect the fluid feed holes for the proper opening.
8. Inspect the bolt hole threads for debris or stripping.
9. Inspect the seal grooves for damage.
10. Clean and dry each component.
Assembly Procedure
1. Assemble the servo cushion springs and the servo piston onto the servo pin.
2. Install the snap ring onto the servo pin in order to retain the servo cushion springs and servo piston.
3. Assemble new seals onto the servo piston and servo cover.
4. Assemble the servo piston assembly into the servo cover. Lubricate the piston seals with transaxle fluid in order to aid in assembly.
Installation Procedure
Important: Hand start and tighten the servo cover bolts evenly to prevent damage to the servo cover bore.
1. Install the servo return spring into the transaxle case.
2. Install the servo cover and piston assembly over the servo return spring.
Notice: Refer to Fastener Notice.
3. Hand start and install the servo cover bolts.
Tighten the servo cover bolts to 12 N.m (9 lb ft).
4. Install the oil pan. Refer to Oil Pan Replacement.
5. Lower the vehicle.
6. Remove the AIR. Refer to Transmission Fluid Checking.
7. Add DEXRON(R) VI transaxle fluid or equivalent to the specified refill capacity.
