G6 V6-3.6L (2007)
Tighten the oil cooler line assembly nut to 7 N.m (62 lb in).
5. Lower the vehicle.
6. Add fluid to the transaxle. Refer to Automatic Transmission Fluid Filter and Seal Replacement.
7. Start the engine and check for leaks.
Output Axle Shaft Sleeve and Seal Replacement
Output Axle Shaft Sleeve and Seal Replacement
Tools Required
^
J 41227 Output Shaft Sleeve Remover
^
J 41228 Output Shaft Sleeve Installer
Removal Procedure
1. Raise the vehicle. Support the vehicle. Refer to Vehicle Lifting.
2. Remove the drive axle assembly. Refer to Wheel Drive Shaft Replacement.
3. Remove the snap ring from axle.
4. Remove the output axle seal.
5. Use the J 41227 to remove the sleeve from the output axle.
Installation Procedure
