G6 V6-3.6L (2007)
Important: The output axle shaft sleeve and seal must be replaced together. DO NOT replace the sleeve or seal separately.
1. Install the new output axle seal.
2. Use the J 41228 to install a new sleeve on the output axle shaft. Ensure that the collet is located in the snap ring groove when installing.
3. Install one new snap ring on the output shaft.
4. Install the drive axle assembly. Refer to Wheel Drive Shaft Replacement.
5. Lower the vehicle.
6. Inspect the output axle shaft sleeve for leaks.
7. Inspect the oil level. Refer to Transmission Fluid Checking.
Stub Axle Shaft Sleeve and Seal Replacement
Stub Axle Shaft Sleeve and Seal Replacement
Tools Required
^
J 38868 Shaft Removal Tool
^
J 6125-1B Slide Hammer
^
J 23129 Universal Seal Remover
^
J 41102-1A Axle Seal Installer
^
J 41227 Output Shaft Sleeve Remover
^
J 41228 Output Shaft Sleeve Installer
Removal Procedure
