G6 V6-3.6L (2007)
Important: Do not damage the seal bore or the sleeve assembly. Fluid leaks may result.
1. Raise and support the vehicle. Refer to Battery Negative Cable Disconnection and Connection.
2. Remove the drive axle assembly. Refer to Wheel Drive Shaft Replacement.
3. Remove the snap ring from the stub axle shaft. Discard the snap ring. Do not reuse.
4. Remove the stub shaft from the transmission. Use the J 6125-1B and the J 38868.
5. Pull lightly on the shaft. Rotate the shaft until the stub shaft snap ring at the differential seats in the taper on the differential side gear.
6. Remove inner snap ring.
7. Using J 41227, remove the sleeve from the shaft.
8. Remove the right hand axle seal from the transmission. Use the J 23129 and the J 6125-1B.
