G6 V6-3.6L (2007)
Important: The holes in the control valve body cover wiring connector hole seal must face toward the TCM. If the holes face toward the
valve body cover, there is a potential for a leak around the seal.
1. Install the control valve body cover wiring connector hole seal to the TCM.
2. Install the control valve body cover gasket to the control valve body cover.
3. Install the control valve body cover.
4. Lower the transmission and remove the transmission jack.
Important: Install all control valve body cover bolts and studs by hand then torque all bolts and studs in sequence.
Notice: Refer to Fastener Notice.
5. Install the control valve body cover bolts (1) M6 x 30 (Qty: 12).
Tighten the bolts in sequence to 12 N.m (106 lb in).
6. Install the control valve body cover studs (2) M6 x 30 (Qty: 2).
Tighten the studs in sequence to 12 N.m (106 lb in).
