G6 V6-3.9L (2009)
Convertible Top Deck Lid: Adjustments
Folding Top Storage Compartment Closeout Panel Adjustment - Front
Folding Top Storage Compartment Closeout Panel Adjustment - Front
Important:
*
Due to the tight clearance of the storage compartment front closeout panel to the upper rear end trim finish panel and the rear roof panel
headliner, slowly cycle the folding top a few seconds at a time to ensure panels are moving properly and not hanging up or interfering
with the folding top.
*
Inspect the closeout panels with the folding top in the down position. Align the closeout panels so there is an even gap to the upper trim
finish panel and to each other. Also ensure there is a consistent closeout of the panel seals to the rear compartment lid.
Fore/Aft Adjustment Procedure
Important: The folding top will only remain in partial open or closed position for 3 minutes before the hydraulic pressure is released and the
top will descend. For adjustments exceeding this time limit, place the folding top in the service position. Refer to Folding Top Retainer Strap
Installation Position (See: Locations/Folding Top Retainer Strap Installation Position).
1. Cycle the folding top until the storage compartment closeout panels are in the vertical position.
2. Loosen the front storage compartment closeout panel hinge bolts (1) to allow adjustment of the closeout panel. Refer to Folding Top Stowage
Compartment Closeout Panel Hinge Replacement - Front (See: Service and Repair/Removal and Replacement/Folding Top Stowage
Compartment Closeout Panel Hinge Replacement - Front).
