G6 V6-3.9L (2009)
19. Rotate the pump outward, to access hydraulic lines manifold bolts (1).
20. Remove the bolts (1) from the pump manifold plate.
Identify the hose numbers to be replaced.
21. Remove the reservoir filler plug.
22. Carefully lift up on the manifold plate (1).
23. Locate the pair of cylinder hoses that need replacement. Refer to Folding Top Hydraulic Cylinder Hose Identification (See: Locations/Folding
Top Hydraulic Cylinder Hose Identification).
Note: Remove the two hoses connections one at a time. Repeat the following procedure for the second hose.
24. For each set of hoses being replaced, remove one hose by pulling straight up from the pump. Use a clean shop towel to control any hydraulic fluid
leakage.
25. Push the hose back through the manifold plate.
