G6 V6-3.9L (2009)
Driver or Passenger Seat Back Cushion Finish Panel Replacement
Removal Procedure
Warning: Refer to SIR Warning (See: Restraint Systems/Service Precautions/SIR Warning).
1. Remove the lumbar knob, if equipped. Refer to Lumbar Support Knob Replacement (See: Service and Repair/Removal and Replacement/Lumbar
Support Knob Replacement).
Note: Take special care when removing the trim. Start at the arched portion, and work counter-clockwise around the trim, ending at the upper
most point. To disengaged the upper most clip, pivot the trim forward.
2. Remove the inflatable restraint side impact module trim (1).
3. Starting at the top of the seat back panel, remove the push-in retainers by pulling the panel from the seat back frame.
4. Remove the seat back panel from the seat back frame by pulling straight up to release the lower hooks.