G6 V6-3.9L (2009)
7. Connect the master cylinder secondary brake pipe fitting (1).
Tighten the fitting to 32 Nm (24 lb ft).
8. Install the vacuum check valve (1) to the vacuum brake booster grommet.
If necessary, a small amount of denatured alcohol may be used as a lubricant for assembly. Do not use soap.
9. Connect the brake fluid level indicator switch electrical connector.
10. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual) (See: Brake Bleeding/Service and Repair)Hydraulic
Brake System Bleeding (Pressure) (See: Brake Bleeding/Service and Repair).