G6 V6-3.9L (2009)
Installation Procedure
1. Apply clean engine oil to the NEW oil filter gasket.
2. Install the NEW oil filter and tighten 3/4 to 1 full turn , after the oil filter gasket contacts the adapter.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
3. Tighten the oil pan drain plug to 26 Nm (19 lb ft).
4. Remove the oil drain pan from under the vehicle.
5. Lower the vehicle.
6. Fill the engine with new engine oil. Refer to Approximate Fluid Capacities (See: Maintenance/Service Intervals) and Fluid and Lubricant
Recommendations (See: Maintenance/Service Intervals).
7. Start the engine.
8. Inspect the for oil leaks after engine start up.
9. Turn OFF the engine and allow the oil a few minutes to drain back into the oil pan.
