G6 V6-3.9L (2009)
Installation Procedure
1. Rotate the drive belt tensioner counterclockwise in order to release the tensioner spring tension.
2. Install the drive belt.
Note: The spacer has a nominal length of 36.0 mm (1.42 in). If the spacer cannot be reinstalled, the spacer will require the ends to be buffed
slightly using a crocus cloth or emery paper in order to bring the length to a minimum of 35.80 mm (1.41 in).
3. Install the engine mount bracket spacer (1).
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
4. Install the engine mount bracket bolt (2).
Tighten the bolt to 50 Nm (37 lb ft).
