G6 V6-3.9L (2009)
4. Install the junction block connector cover.
5. Turn the junction block right side up.
6. Install the junction block to the battery tray by pushing the electrical center into the retainer tab.
7. Install all of the fuses and the relays.
8. Install the positive battery cable lead to the stud on underhood junction block, then install the positive battery cable lead retaining nut.
Tighten the positive battery cable lead retaining nut to 10 Nm (89 lb in).
9. Install the relay cover.
10. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (See: Starting and Charging/Battery/Battery
Cable/Service and Repair).