G6 V6-3.9L (2009)
2.
Raise the front wheel off the ground.
3.
Attach the J 43485 (Adapter) to the J 23738 (Mityvac), or equivalent. Place the J 43485 on/in the pump reservoir filler neck (refer to graphic).
Apply a vacuum of 20 in Hg MAXIMUM.
Note:
If the J 43485 (adapter) is not available, an equivalent can be made using a rubber seal/stopper and brass fitting.
Important:
An assistant is needed for the next step.
4.
Apply vacuum while turning the steering wheel lock to lock. Maintain 20 in Hg while turning. Using a clear line will allow you to see bubbles
evacuating system. Stop when no more bubbles are seen.
5.
Wait five minutes. Typically vacuum drop is 2-3 in Hg. Verify the fluid level. If the fluid level is low, fill to the full line.
6.
Reinstall the cap. Start and idle the engine.
7.
Turn the engine off. Verify the fluid level. If the fluid level drops, add fluid. Repeat Steps 4 and 5 until the fluid level stabilizes.
8.
Start and idle the engine. Turn the steering wheel 180° - 180° in both directions five times. DO NOT TURN TO LOCK.
9.
Switch the ignition off. Verify the fluid level.
10.
Install the cap. The bleed procedure is complete.
Warranty Information
Disclaimer
