G6 V6-3.9L (2009)
15. Position the outer tie rod ends into the steering knuckles.
Note: Hold the ball stud from turning during installation of the castle nut.
16. Install new torque castle nuts to the tie rod end ball studs.
Tighten the castle nuts to 25 Nm (18 lb ft) plus an additional 90 degree rotation.
17. Install the front tires and wheels. Refer to Tire and Wheel Removal and Installation (See: Wheels and Tires/Service and Repair).
18. Lower the vehicle.
19. Fill and bleed the power steering system. Refer to Power Steering System Bleeding (See: Power Steering/Power Steering Bleeding/Service and
Repair).
20. Measure the wheel alignment and adjust as necessary. Refer to Wheel Alignment Measurement (See: Alignment/Service and Repair/Wheel
Alignment Measurement).
