G6 V6-3.9L (2009)
Band Apply Servo: Service and Repair
4T45-E - Automatic Transmission
Low/Reverse Servo Assembly Replacement
Low/Reverse Servo Assembly Replacement
Removal Procedure
Warning
Ensure that the vehicle is properly supported and squarely positioned. To help avoid personal injury when a vehicle is on a hoist, provide additional
support for the vehicle on the opposite end from which the components are being removed.
1. Position the vehicle on a hoist and raise the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and
Repair).
2. Remove the transaxle oil pan. Refer to Oil Pan Replacement (See: Fluid Pan/Service and Repair/4T45-E - Automatic Transmission).
3. Remove the oil feed pipe-to-low/reverse servo assembly bolt.
Note: Remove servo cover bolts evenly to prevent damage to servo cover.
4. Remove the low and reverse band servo cover assembly bolts.
5. Pull the oil feed pipe away from the servo cover and remove the servo assembly.
Disassembly Procedure
