G6 V6-3.9L (2009)
7. Remove the oil feed pipe assembly bolts and remove the assembly.
8. Remove the low and reverse band oil pipe assembly seals.
Installation Procedure
1. Inspect the oil feed pipes for plugged passages, bent pipes, or cracks.
2. Inspect the oil feed pipe seal rings in order to verify the proper location of the seal rings.
Note: The oil feed pipe seals are glued into place during the initial assembly. If a seal ring is to be replaced, be sure to thoroughly clean any
residual glue from the feed pipes.
3. Replace the seal rings only if they are cut, swelled, or damaged.
