G6 V6-3.9L (2009)
9. Install a NEW snap ring on the output shaft.
10. Install the drive axle assembly. Refer to Wheel Drive Shaft Replacement (See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service
and Repair).
11. Lower the vehicle.
12. Inspect the output axle shaft sleeve for leaks.
13. Inspect the oil level. Refer to Transmission Fluid Check (See: Testing and Inspection/Symptom Related Diagnostic Procedures/4T45-E -
Automatic Transmission/Transmission Fluid Check).
Front Wheel Drive Shaft Seal and Output Shaft Sleeve - Right
Front Wheel Drive Shaft Seal and Output Shaft Sleeve Replacement - Right Side
Special Tools
*
J 6125-1B Slide Hammer
*
J 8092 Driver Handle
*
J 23129 Universal Seal Remover
*
J 38868 Shaft Removal Tool
*
J 41102-1A Axle Seal Installer
*
J 41227 Output Shaft Sleeve Remover
*
J 41228 Output Shaft Sleeve Installer
Removal Procedure
Note:
*
The stub axle shaft sleeve and seal must be replaced together. DO NOT replace the sleeve or seal separately.
*
Do not damage the seal bore or the sleeve assembly. Fluid leaks may result.
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair).
2. Remove the right drive axle assembly. Refer to Wheel Drive Shaft Replacement (See: Drive Axles, Bearings and Joints/Axle Shaft
Assembly/Service and Repair).