G6 V6-3.9L (2009)
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the TFP switch assembly onto the control valve body assembly and install the bolts.
Tighten the control valve body bolts to 12 Nm (9 lb ft).
3. Install the transaxle case side cover. Refer to Control Valve Body Cover Replacement (See: Valve Body/Service and Repair/4T45-E - Automatic
Transmission/Control Valve Body Cover Replacement).
4. Start the engine, warm up the transaxle, and check for leaks.
5. Inspect for proper fluid level. Refer to Transmission Fluid Check (See: Testing and Inspection/Symptom Related Diagnostic Procedures/4T45-E
- Automatic Transmission/Transmission Fluid Check).
Note: It is recommended that transmission adaptive pressure (TAP) information be reset.
Resetting the TAP values using a scan tool will erase all learned values in all cells. As a result, The ECM, PCM or TCM will need to relearn TAP
values. Transmission performance may be affected as new TAP values are learned.
6. Reset the TAP values. Refer to Transmission Adaptive Functions (See: Description and Operation/4T45-E - Automatic
Transmission/Transmission Adaptive Functions).
