G6 V6-3.9L VIN 1 (2006)
Garage Door Opener Transmitter: Service and Repair
Garage Door Opener Replacement
GARAGE DOOR OPENER REPLACEMENT
REMOVAL PROCEDURE
1. Remove the overhead console.
2. Remove the fasteners from the garage door opener.
3. Disconnect the electrical connector and remove the garage door opener.
INSTALLATION PROCEDURE
1. Install the garage door opener and connect the electrical connector.
2. Install the fasteners to the garage door opener.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the fastener to 2.5 N.m (22 lb in).
3. Install the overhead console.
4. Program the garage door opener after replacement. Refer to Control Module References in Computer/Integrating Systems. See: Testing and
Inspection/Programming and Relearning
